pros and cons of the use of a 3d scanner in reverse engineering

Discussion in 'General 3D and Stereoscopic Discussion' started by EmmaLewis, Dec 17, 2020.

  1. EmmaLewis

    EmmaLewis New Member

    Joined:
    Dec 17, 2020
    Messages:
    1
    Likes Received:
    0
    I’ve seen this video about how 3D scanners are used for reverse engineering, and I’m quite fascinated by its concept. For those who’ve done handheld 3d scanner reverse engineering, what do you think are the pros and cons of this process and technique? Any insight and useful discussion on this based on your experiences would be greatly appreciated! Thanks in advance!
     
    EmmaLewis, Dec 17, 2020
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.